Performance of Combined PCM/Metal Foam-based Photovoltaic Thermal (PVT) Collector

Mojtaba Dayer, Kamaruzzaman Sopian, Adnan Ibrahim, Anwer B. Al-Aasam, Bassam Abdulsahib M., Saeed Rahmanian, Ag Sufiyan Abd Hamid

Abstract


Photovoltaic thermal collector (PVT) is a power generation technology that adapts solar radiation into electrical and thermal energy. There are two cooling methods in PV panels: active and passive. Phase Change Materials (PCM) have high latent heat during charging and discharging, making them promising as thermal energy storage. However, their low thermal conductivity remains a major drawback, which was to be solved by porous metal foams given their high thermal conductivity, low density, and lightness. This study aimed to introduce and analyze a novel PVT design by integrating PCM with Copper Foam Matrix (CFM) as passive cooling combined with submerged serpentine copper tubes for fluid flow as active cooling. This novel PVT was run with and without CFM by conducting a 3D steady-state simulation using COMSOL Multiphysics. This study showed that incorporating the PCM plus CFM will decrease the PV surface temperature and increase electrical efficiency. The effective thermal conductivity of PCM increased, leading to higher thermal extraction at the tested mass flow rates. At an irradiance of 1000W/m2 and an ambient temperature of 20?C, the collector achieved 65% and 13% thermal and electrical efficiency, respectively.

Keywords


solar energy, renewable energy,

Full Text:

PDF

References


Daghigh, R., et al., Monthly performance of a photovoltaic thermal (PV/T) water heating system. 2011.

Farshchimonfared, M., J.I. Bilbao, and A.B. Sproul, Full optimisation and sensitivity analysis of a photovoltaic–thermal (PV/T) air system linked to a typical residential building. Solar Energy, 2016. 136: p. 15-22.

Meng, X.-l., et al., A novel free-form Cassegrain concentrator for PV/T combining utilization. Solar Energy, 2016. 135: p. 864-873.

Yazdanifard, F., E. Ebrahimnia-Bajestan, and M. Ameri, Investigating the performance of a water-based photovoltaic/thermal (PV/T) collector in laminar and turbulent flow regime. Renewable Energy, 2016. 99: p. 295-306.

Tripanagnostopoulos, Y., et al., Energy, cost and LCA results of PV and hybrid PV/T solar systems. Progress in Photovoltaics: Research and Applications, 2005. 13: p. 235-250.

Hegazy, A., Comparative study of performance of four photovoltaic/thermal solar air collectors. Energy Conversion and Management, 2000. 41: p. 861-881.

Kazanci, O.B., et al., Sustainable heating, cooling and ventilation of a plus-energy house via photovoltaic/thermal panels. Energy and Buildings, 2014. 83: p. 122-129.

Qiu, Z., et al., Theoretical investigation of the energy performance of a novel MPCM (Microencapsulated Phase Change Material) slurry based PV/T module. Energy, 2015. 87: p. 686-698.

Hasan, A., et al., Energy and Cost Saving of a Photovoltaic-Phase Change Materials (PV-PCM) System through Temperature Regulation and Performance Enhancement of Photovoltaics. Energies, 2014. 7(3): p. 1318-1331.

Fiorentini, M., P. Cooper, and Z. Ma, Development and optimization of an innovative HVAC system with integrated PVT and PCM thermal storage for a net-zero energy retrofitted house. Energy and Buildings, 2015. 94: p. 21-32.

Tao, Y.B., Y. You, and Y.L. He, Lattice Boltzmann simulation on phase change heat transfer in metal foams/paraffin composite phase change material. Applied Thermal Engineering, 2016. 93: p. 476-485.

Zhou, D. and C.Y. Zhao, Experimental investigations on heat transfer in phase change materials (PCMs) embedded in porous materials. Applied Thermal Engineering, 2011. 31(5): p. 970-977.

Du, Y. and Y. Ding, Towards improving charge/discharge rate of latent heat thermal energy storage (LHTES) by embedding metal foams in phase change materials (PCMs). Chemical Engineering and Processing: Process Intensification, 2016. 108: p. 181-188.

Hwang, G., C. Wu, and C.-H. Chao, Investigation of Non-Darcian Forced Convection in an Asymmetrically Heated Sintered Porous Channel. Journal of Heat Transfer-transactions of The Asme - J HEAT TRANSFER, 1995. 117: p. 725-732.

Boomsma, K. and D. Poulikakos, Corrigendum for the paper: K. Boomsma, D. Poulikakos, “On the effective thermal conductivity of a three-dimensionally structured fluid-saturated metal foam” International Journal of Heat and Mass Transfer, 44 (2001) 827–836]. International Journal of Heat and Mass Transfer, 2011. 54(1): p. 746-748.

Hong, Y., et al., Solid-liquid phase-change thermal storage and release behaviors in a rectangular cavity under the impacts of mushy region and low gravity. International Journal of Heat and Mass Transfer, 2019. 130: p. 1120-1132.

Fadl, M. and P.C. Eames, Numerical investigation of the influence of mushy zone parameter Amush on heat transfer characteristics in vertically and horizontally oriented thermal energy storage systems. Applied Thermal Engineering, 2019. 151: p. 90-99.

Žukauskas, A., Heat Transfer from Tubes in Crossflow, in Advances in Heat Transfer, J.P. Hartnett and T.F. Irvine, Editors. 1972, Elsevier. p. 93-160.

Zhang, X., et al., Three-dimensional numerical investigation on melting performance of phase change material composited with copper foam in local thermal non-equilibrium containing an internal heater. International Journal of Heat and Mass Transfer, 2021. 170: p. 121021.

Abdulateef, A.M., et al., Optimal fin parameters used for enhancing the melting and solidification of phase-change material in a heat exchanger unite. Case Studies in Thermal Engineering, 2019. 14: p. 100487.

Browne, M.C., B. Norton, and S.J. McCormack, Heat retention of a photovoltaic/thermal collector with PCM. Solar Energy, 2016. 133: p. 533-548.

Mousavi, S., et al., Numerical investigation of the effects of a copper foam filled with phase change materials in a water-cooled photovoltaic/thermal system. Energy Conversion and Management, 2018. 163: p. 187-195.

Duffie, J.A. and W.A. Beckman, Solar Engineering of Thermal Processes. 1980: Wiley.

Ahmad, E., et al., Recent advances in passive cooling methods for photovoltaic performance enhancement. International Journal of Electrical and Computer Engineering, 2021. 11: p. 146-154.

Ahmad, E., et al., Experimental investigation of passively cooled photovoltaic modules on the power output performance. International Journal of Power Electronics and Drive Systems, 2022. 13: p. 520-527.

Ajeel, R.K., et al., Numerical investigation of binary hybrid nanofluid in new configurations for curved-corrugated channel by thermal-hydraulic performance method. Powder Technology, 2021. 385: p. 144-159.

Al-Waeli, A.H.A., et al., Photovoltaic/Thermal (PV/T) systems: Status and future prospects. Renewable and Sustainable Energy Reviews, 2017. 77: p. 109-130.

Saidur, R., et al., Exergy analysis of solar energy applications. Renewable and Sustainable Energy Reviews, 2012. 16(1): p. 350-356.




DOI (PDF): https://doi.org/10.20508/ijrer.v13i2.13881.g8723

Refbacks

  • There are currently no refbacks.


Online ISSN: 1309-0127

Publisher: Gazi University

IJRER is cited in SCOPUS, EBSCO, WEB of SCIENCE (Clarivate Analytics);

IJRER has been cited in Emerging Sources Citation Index from 2016 in web of science.

WEB of SCIENCE in 2025; 

h=35,

Average citation per item=6.59

Last three Years Impact Factor=(1947+1753+1586)/(146+201+78)=5286/425=12.43

Category Quartile:Q4