Thermal and Thermo-hydraulic Performance of Finned Double-Pass Solar Air Collector Utilizing Cylindrical Capsules Nano-Enhanced PCM

Jalal Assadeg, Kamaruzzaman Sopian, Adnan Ibrahim, Ahmad Fudholi, Ali H. A. Alwaeli, Ag Sufiyan Abd Hamid

Abstract


Double-pass solar air collector with a finned absorber and nano-enhanced PCM in the lower channel is one of the significant and attractive designs proposed to improve the performance. This research paper presents a novel mathematical model of steady-state equilibrium equations created and developed for two air streams: the glass cover, absorber plate, fins, nano-enhanced PCM capsules, and back plate. The influence of various operating parameters on thermal and thermo-hydraulic performance was presented and discussed. The simulations were conducted at air mass flow rates from 0.02 kg/s through 0.06 kg/s and solar irradiance levels ranging from 475 W/m2 to 1000 W/m2. The proposed collector has an optimal energy efficiency of 80%, an exergy efficiency of 18.2% at solar irradiance of 1000 W/m2, and a mass flow rate of 0.06 kg/s. The minimum and maximum improvement potentials for solar irradiance levels of 475–1000 W/m2 at an ambient temperature of 298 K are 163–237 W. The proposed collector's best findings in the current study are 1.0 m in length and a width of roughly 0.3 m for air mass flow rates of 0.02-0.06 kg/s.

Keywords


solar energy, renewable energy,

Full Text:

PDF

References


Evangelisti, L., R. De Lieto Vollaro, and F. Asdrubali, Latest advances on solar thermal collectors: A comprehensive review. Renewable and Sustainable Energy Reviews, 2019. 114: p. 109318.

Devendiran, D.K. and V.A. Amirtham, A review on preparation, characterization, properties and applications of nanofluids. Renewable and Sustainable Energy Reviews, 2016. 60: p. 21-40.

Chen, S.-B., et al., Combined effect of using porous media and nano-particle on melting performance of PCM filled enclosure with triangular double fins. Case Studies in Thermal Engineering, 2021. 25: p. 100939.

Elarem, R., et al., Numerical study of an Evacuated Tube Solar Collector incorporating a Nano-PCM as a latent heat storage system. Case Studies in Thermal Engineering, 2021. 24: p. 100859.

Liu, L., et al., Evaluation of the energy storage performance of PCM nano-emulsion in a small tubular heat exchanger. Case Studies in Thermal Engineering, 2021. 26: p. 101156.

Golberg, D., et al., Nanomaterial engineering and property studies in a transmission electron microscope. Advanced materials, 2012. 24(2): p. 177-194.

Bouhal, T., et al., PCM addition inside solar water heaters: Numerical comparative approach. Journal of Energy Storage, 2018. 19: p. 232-246.

Frusteri, F., et al., Thermal conductivity measurement of a PCM

based storage system containing carbon fibers. Applied thermal engineering, 2005. 25(11-12): p. 1623-1633.

Al-Jethelah, M., et al., Nano-PCM filled energy storage system for solar-thermal applications. Renewable Energy, 2018. 126: p. 137-155.

Rostami, S., et al., A review of melting and freezing processes of PCM/nano-PCM and their application in energy storage. Energy, 2020. 211: p. 118698.

Ebadi, S., et al., Melting of nano-PCM inside a cylindrical thermal energy storage system: Numerical study with experimental verification. Energy Conversion and Management, 2018. 166: p. 241-259.

Liu, W., et al., A Review on Thermal Properties Improvement of Phase Change Materials and its Combination with Solar Thermal Energy Storage. Energy Technology, 2021.

Sarafraz, M., et al., Experimental investigation on thermal performance of a PV/T-PCM (photovoltaic/thermal) system cooling with a PCM and nanofluid. Energies, 2019. 12(13): p. 2572.

Bondareva, N.S. and M.A. Sheremet, Effect of nano-sized heat transfer enhancers on PCM-based heat sink performance at various heat loads. Nanomaterials, 2020. 10(1): p. 17.

Alam, T. and M.-H. Kim, Performance improvement of double-pass solar air heater–A state of art of review. Renewable and Sustainable Energy Reviews, 2017. 79: p. 779-793.

Omojaro, A. and L. Aldabbagh, Experimental performance of single and double pass solar air heater with fins and steel wire mesh as absorber. Applied energy, 2010. 87(12): p. 3759-3765.

Al-Waeli, A.H.A., et al., Modeling and experimental validation of a PVT system using nanofluid coolant and nano-PCM. Solar Energy, 2019. 177: p. 178-191.

M. Alkilani, M., et al., Output Air Temperature Prediction in a Solar Air Heater Integrated with Phase Change Material. Vol. 27. 2009.

Dermardiros, V., Y. Chen, and A.K. Athienitis, Modelling of an Active PCM Thermal Energy Storage for Control Applications. Energy Procedia, 2015. 78: p. 1690-1695.

Ho, C.-D., H.-M. Yeh, and T.-C. Chen, Collector efficiency of upward-type double-pass solar air heaters with fins attached. International Communications in Heat and Mass Transfer, 2011. 38(1): p. 49-56.

Fudholi, A., et al., Energy analysis and improvement potential of finned double-pass solar collector. Energy Conversion and Management, 2013. 75: p. 234-240.

Alvarez, A., et al., Experimental and numerical investigation of a flat-plate solar collector. Energy, 2010. 35(9): p. 3707-3716.

El-Sebaii, A., et al., Investigation of thermal performance of-double pass-flat and v-corrugated plate solar air heaters. Energy, 2011. 36(2): p. 1076-1086.

Abo-Elfadl, S., et al., Energy, exergy, and economic analysis of tubular solar air heater with porous material: An experimental study. Applied Thermal Engineering, 2021. 196: p. 117294.

Ong, K.S., Thermal performance of solar air heaters: Mathematical model and solution procedure. Solar Energy, 1995. 55(2): p. 93-109.

John A. Duffie, W.A.B., Solar Engineering of Thermal Processes. 4th ed. 2013: New York: Wiley.

Assadeg, J., et al., Energetic and exergetic analysis of a new double pass solar air collector with fins and phase change material. Solar Energy, 2021. 226: p. 260-271.

Naphon, P., On the performance and entropy generation of the double-pass solar air heater with longitudinal fins. Renewable Energy, 2005. 30(9): p. 1345-1357.

Hegazy, A.A., Thermohydraulic performance of air heating solar collectors with variable width, flat absorber plates. Energy Conversion and Management, 2000. 41(13): p. 1361-1378.

Abu?ka, M. and S. ?evik, Energy, exergy, economic and environmental (4E) analyses of flat-plate and V-groove solar air collectors based on aluminium and copper. Solar Energy, 2017. 158: p. 259-277.

Verma, R., R. Chandra, and H. Garg, Optimization of solar air heaters of different designs. Renewable Energy, 1992. 2(4-5): p. 521-531.

Fudholi, A., et al., Performance and cost benefits analysis of double-pass solar collector with and without fins. Energy Conversion and Management, 2013. 76: p. 8-19.

Bashria, A., et al., Analysis of single and double passes V-grooves solar collector with and without porous media. Int. J. Energy Environ, 2007. 2(1): p. 109-114.

Gool, W.V., Energy policy: fairy tales and factualities, in Innovation and technology—strategies and policies. 1997, Springer. p. 93-105.




DOI (PDF): https://doi.org/10.20508/ijrer.v13i1.13880.g8668

Refbacks

  • There are currently no refbacks.


Online ISSN: 1309-0127

Publisher: Gazi University

IJRER is cited in SCOPUS, EBSCO, WEB of SCIENCE (Clarivate Analytics);

IJRER has been cited in Emerging Sources Citation Index from 2016 in web of science.

WEB of SCIENCE in 2025; 

h=35,

Average citation per item=6.59

Last three Years Impact Factor=(1947+1753+1586)/(146+201+78)=5286/425=12.43

Category Quartile:Q4