Pyrolysis of Corncobs to Produce Biobased Conductive Materials as Electrodes for Potential Application in Microbial Fuel Cells (MFCs)

Musa Bishir, Marium Tariq, Jan Willem Straten, Dominik Wüst, Joshua Oluyinka Ajikashile, Andrea Kruse

Abstract


Despite large varieties of commercially available electrodes, only few are suitable for electro-active bacterial colonization during biofilm formation in microbial fuel cells (MFCs), and most of these electrodes are cost prohibitive. Hence there is need to search for low-cost alternative electrodes for MFCs. Pyrochars were produced in this study by pyrolysis (600 °C and a continuous flow rate of 3 L/min of nitrogen gas for 30 min) and subsequently steam and potassium hydroxide (KOH) activation of the pyrochar at 600 °C were carried out accordingly. Physicochemical, structural, and electrochemical properties of the activated and non-activated pyrochars were determined according to standardized analytical methods. According to BET, 1626 m2 g-1 surface area and 14.74 Å pore diameter were obtained from the KOH-activated pyrochar which was also the most conductive (0.26 S m-1). Chemical activation of pyrochar with KOH resulted in increased electrical conductivity (EC), pore diameter, and most importantly the material’s surface area according to the findings. In conclusion, KOH-activated corncob pyrochar holds potentials for producing electrode materials with desirable characteristics for successful application in MFC compared to the non-activated and steam-activated pyrochars of the same biomass. 


Keywords


Corncob; Pyrolysis; Pyrochar; Electrode; MFC; Activation

Full Text:

PDF

References


References

T. Huggins, H. Wang, J. Kearns, P. Jenkins and Z. J. Ren, “Biochar as a sustainable electrode material for electricity production in microbial fuel cells,” Bioresource Technology, vol. 157 , pp. 114-119, 2014 .

Q. Huang, S. Song, Z. Chen, B. Hu, J. Chen and X. Wang, “Biochar-based materials, and their applications in removal of organic contaminants from wastewater: state-of-the-art review.,” Biochar, vol. 1, pp. 45-73, 2019.

M. Sevilla and M. M. Titirici, “'Bol. Grupo Español Carbón’,” 2012.

T. Jalalabadi, M. Glenn, P. Tremain, B. Moghtaderi, S. W. Donne and J. Allen, “Modification of biochar formation during slow pyrolysis in the presence of alkali metal carbonate additives.,” Energy Fuels, vol. 33, no. 11, pp. 11235-11245, 2019.

F. Ronsse, S. van Hecke, D. Dickinson and W. Prins, “Production and characterization of slow pyrolysis biochar: influence of feedstock type and pyrolysis conditions,” GCB Bioenergy, vol. 5, no. 2, pp. 104-115, 2013.

E. Pérez-Mayoral, I. Matos, M. Bernardo and I. Fonseca, “New and Advanced Porous Carbon Materials in Fine Chemical Synthesis,” Catalysts, vol. 9, no. 2, p. 133, 2019. DOI: https://doi.org/10.3390/catal9020133.

J. S. Mcdonald-Wharry, M. Manley-Harris and K. L. Pickering, “Reviewing, Combining, and Updating the Models for the Nanostructure of Non-Graphitizing Carbons Produced from Oxygen-Containing Precursors,” Energy Fuels, vol. 30, no. 10, pp. 7811-7826, 2016.

B. S. Patil and K. S. Kulkarni, “Development of High Surface Area Activated Carbon from Waste Material,” International Journal of Advanced Engineering Research and Studies, vol. 1, no. 2, pp. 109-113, 2012.

T. S. Hui and M. A. A. Zaini, “Potassium hydroxide activation of activated carbon: A commentary,” Carbon Letters, vol. 16, no. 4, pp. 275-280, 2015.

S. Hirunpraditkoon, N. Tunthong, A. Ruangchai and K. Nuithitikul, “Adsorption Capacities of Activated Carbons Prepared from Bamboo by KOH Activation,” vol. 5, no. 6, pp. 477-481, 2011. DOI: http://doi.org/10.5281/zenodo.1055445.

X. Li., X. Luo, L. Dou and K. Chen, “Preparation and Characterization of K2CO3-Activated Kraft Lignin Carbon,” BioResources, vol. 11, no. 1, pp. 2096-2108, 2016.

B. Viswanathan, P. I. Neel and T. K. Varadarajan, Methods of Activation and Specific Applications of Carbon Materials, Chennai, India, : Indian Institute of Technology Madras, 2009. .

B. Musa, P. J. Arauzo, M. P. Olszewski and A. Kruse, “Electricity generation in microbial fuel cell from wet torrefaction wastewater and locally developed corncob electrodes,” Fuel Cells, vol. 21, no. 2, pp. 82-194, 2021.

M. Mathew, S. Radhakrishnan, A. Vaidyanathan, B. Chakraborty and C. S. Rout, “Flexible and wearable electrochemical biosensors based on two-dimensional materials: Recent developments,” Analytical and Bioanalytical Chemistry, vol. 413, pp. 727-762, 2021.

S. Kalathil, S. A. Patil and D. Pant, “Microbial Fuel Cells: Electrode Materials,” Encyclopedia of Interfacial Chemistry, pp. 13459-13466, 2018.

M. P. Olszewski, P. J. Arauzo, M. W?drzyk and A. Kruse, “Py-GC-MS of hydrochars produced from brewer’s spent grains,” Journal of Analytical and Applied Pyrolysis, vol. 140, pp. 255-263, 2019.

APHA., Standard methods for the examination of water and wastewater., 18 ed., Washington, DC.: American Public Health Association, 1992.

V. J. D. Hoffmann, J. Zimmermann, C. C. Rodriguez, A. Elleuch, K. Halouani and A. Kruse, “Conductive Carbon Materials from the Hydrothermal Carbonization of Vineyard Residues for the Application in Electrochemical Double-Layer Capacitors (EDLCs) and Direct Carbon Fuel Cells (DCFCs),” Materials, , vol. 12, no. 10, p. 703, 2019 .

A. Celzard, J. Marêché, F. Payot and G. Furdin, “Electrical conductivity of carbonaceous powders,” Carbon, vol. 40, no. 15, pp. 2801-2815, 2002.

S. Brunauer, P. H. Emmett and E. Teller, “Adsorption of Gases in Multimolecular Layers,” Journal of the American Chemical Society, vol. 60, no. 2, pp. 309-319, 1938.

P. C. Hiemenz and R. Rajagopalan, Principles of Colloid and Surface Chemistry, Abingdon: Taylor & Francis Ltd., 1997, p. 1–672.

V. Hoffmann, C. R. Correa, D. Sautter, E. Maringolo and A. Kruse, “Study of the electrical conductivity of biobased carbonaceous powder materials under moderate pressure for the application as electrode materials in energy storage technologies,” GCB Bioenergy , vol. 11, pp. 230-248, 2019.

S. Maulina and M. Iriansyah, “Characteristics of activated carbon resulted from pyrolysis of the oil palm fronds powder,” Material Science and Engineering, vol. 309, no. 1, pp. 0-6, 2018.

G. Pari, S. Darmawan and B. Prihandoko, “Porous Carbon Spheres from Hydrothermal Carbonization and KOH Activation on Cassava and Tapioca Flour Raw Material,” Procedia Environmental Sciences, vol. 20, pp. 342-351, 2014.

S. Schimmelpfennig and B. Glaser, “One step forward toward characterization: some important material properties to distinguish biochars,” Journal of Environmental Quality, vol. 41, pp. 1001-1013, 2012. DOI: 10.2134/jeq2011.0146.

A. Visconti, M. Miccio and D. Juchelková, “An Aspen Plus® tool for simulation of lignocellulosic biomass pyrolysis via equilibrium and ranking of the main process variables,” International Journal of Mathematical Models and Methods in Applied Sciences, vol. 9, p. 70–86, 2015.

X. X., S. Zongkang, M. Peiyong, Y. Jin and W. Zhaobin, “Establishment of Three Components of Biomass Pyrolysis Yield Model,” Energy Procedia, vol. 66, pp. 293-396, 2015.

M. Shahbaz, A. AlNouss, P. Parthasarathy, A. H. Abdelaal, H. Mackey, G. McKay and T. Al-Ansari, “Investigation of biomass components on the slow pyrolysis products yield using Aspen Plus for techno-economic analysis,” Biomass Conversion and Biorefinery, 2020. DOI: https://doi.org/10.1007/s13399-020-01040-1.

B. Marinho, M. Ghislandi, E. Tkalya, C. Koning and G. de With, “Electrical conductivity of compacts of graphene, multi-wall carbon nanotubes, carbon black, and graphite powder,” Powder Technology, vol. 221, pp. 351-358, 2012.

R. Azargohar and A. K. Dalai, “Steam and KOH activation of biochar: Experimental and modeling studies,” Microporous and Mesoporous Materials, vol. 110, no. 2-3, pp. 413-421, 2008.

R. L. Tseng and S. K. Tseng, “Pore structure and adsorption performance of the KOH-activated carbons prepared from corncob,” Journal of Colloid and Interface Science, vol. 287, no. 2, pp. 428-437, 2005 .

M. Song, B. Jin, R. Xiao, L. Yang, Y. Wu, Z. Zhong and Y. Huang, “The comparison of two activation techniques to prepare activated carbon from corn cob,” Biomass Bioenergy, vol. 48, pp. 250-256, 2013.

W. T. Tsai, C. Y. Chang, S. Y. Wang, C. F. Chang, S. F. Chien and H. F. Sun, “Preparation of activated carbons from corn cob catalyzed by potassium salts and subsequent gasification with CO2,” Bioresource Technology, vol. 78, no. 2, pp. 203-208, 2001.

J. E. Park, G. B. Lee, B. U. Hong and S. Y. Hwang, “Regeneration of activated carbons spent by wastewater treatment using KOH chemical activation,” Applied Sciences, vol. 9, p. 5132, 2019.

L. Qi, X. Tang, Z. Wang and X. Peng, “Pore characterization of different types of coal from coal and gas outburst disaster sites using low temperature nitrogen adsorption approach,” International Journal of Mining Science Technology, vol. 27, no. 2, pp. 371-377, 2017.




DOI (PDF): https://doi.org/10.20508/ijrer.v11i3.12312.g8285

Refbacks

  • There are currently no refbacks.


Online ISSN: 1309-0127

Publisher: Gazi University

IJRER is cited in SCOPUS, EBSCO, WEB of SCIENCE (Clarivate Analytics);

IJRER has been cited in Emerging Sources Citation Index from 2016 in web of science.

WEB of SCIENCE in 2025; 

h=35,

Average citation per item=6.59

Last three Years Impact Factor=(1947+1753+1586)/(146+201+78)=5286/425=12.43

Category Quartile:Q4